What happened?
I have a matrix panel with eight 16x16 panels arranged 4x2
Relais is set to i/o pin 5
I use a poti to control brightness as well as a switch set to an on/off preset.
I setup
a background segment 0-64 , 0-32 (total panel)
A top segment 0-64 , 0-16 with long scrolling text overlay
A bottom segment 0-64 , 16-32 with #DDMM
Everything works fine if this preset is started (also if started at boot)
However if poti is turned to off so that relais cuts power to leds or if the switch is set to off, the text will freeze and no longer scrolls when lights turn back on
To Reproduce Bug
See above
Expected Behavior
Text should be scrolling through power cycles of the relais
Install Method
Self-Compiled
What version of WLED?
WLED 0.15-b6
Which microcontroller/board are you seeing the problem on?
ESP32
Relevant log/trace output
No response
Anything else?
No response
Code of Conduct
What happened?
I have a matrix panel with eight 16x16 panels arranged 4x2
Relais is set to i/o pin 5
I use a poti to control brightness as well as a switch set to an on/off preset.
I setup
a background segment 0-64 , 0-32 (total panel)
A top segment 0-64 , 0-16 with long scrolling text overlay
A bottom segment 0-64 , 16-32 with #DDMM
Everything works fine if this preset is started (also if started at boot)
However if poti is turned to off so that relais cuts power to leds or if the switch is set to off, the text will freeze and no longer scrolls when lights turn back on
To Reproduce Bug
See above
Expected Behavior
Text should be scrolling through power cycles of the relais
Install Method
Self-Compiled
What version of WLED?
WLED 0.15-b6
Which microcontroller/board are you seeing the problem on?
ESP32
Relevant log/trace output
No response
Anything else?
No response
Code of Conduct